Tile Adhesive GP
High performance &premium tile adhesive
Description
Meister Tile Adhesive GP is apremixed cementitious mortar provided with industurial polymers, excellent additives,
graded fillers.
Field of use :
It is suitable for thin layer adhesion of ceramic, mosaic, vitreous tiles, strip fixing of hard foam panels, mineral wool glass
and plaster board panels on concrete masonry and plastered surfaces.
Can be used also for laying aerated concrete block and brick works.
For internal & external use .
Advantages
• Tropical grade to suit Gulf & Middle East working conditions.
• High adhesive bond strength.
• Easy to apply.
Standard compliance: EN 12004 & ANSI 118.1
Application Instructions
Surface Preparation:
All surfaces must be clean, sound and free of all substances that can cause separation.
Surfaces
Tile Adhesive GP can be applied directly on concrete, cement screeds, cement andlime mortar.
For use on gypsum or gypsum board substrates, sealer primer should be applied to the surface prior to the application of
Tile Adhesive GP like Meister SBR bond..Tiles should not be placed on concrete or block work until all shrinkage movement
has taken place.
Mixing
• Stir Tile Adhesive GP into clean water until it is completely free of lumps.
• Approximately 4.5 -5 lit. of water are needed for a 20Kg bag.
Application
A notched spreader is to be usedto comb the mortar horizontally. Place tiles firmly into adhesive bed, ensuring good
contact with a twisting motion. Only apply to areas which can be tiled in the adhesives open wet time.
Joints
It is recommended that when fixing ceramic tiles a minimum spacing of (2 mm) be leftaround each tile.
Finishing
Remove excess adhesive with a damp cloth before material has set. Joint grouting with Meister Tile Grout may be
commenced 24 hours after tileshave been laid.
44
Best Solutions
Technical Data:
Packaging
20kg paper bags
Cleaning
All tools should be cleaned with clean water immediately after use. Curedmaterial can only be removed mechanically
Health and Safety
Tile Adhesive GP contains cement powders when mixed or become damp, releases alkaline that can be harmful to the
skin. During use avoid inhalation of dust and contact with skin and eyes. Wear suitable protective clothing, gloves, eye
protection and respiratory protective equipment. In case of contact with skin, rinse and wash with plenty of soap and water.
In case of contact with eyes, rinse immediately with plenty of clean water and seek medical advice. If swallowed, seek
medical attention immediately, do not induce vomiting.